LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1525 (Seat System) >> Repair Instructions >> Seat Cushion Trim Cover and Pad Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  1. Remove the seat. Refer to Seat Replacement (Power)  or Seat Replacement (Manual) .
  2. Remove the seat belt buckle from the seat frame.
    3. Fig 2: Seat Back Recliner Handle
    GM71223Courtesy of GENERAL MOTORS CORP.
  3. Remove the recliner handle.
    1. With a suitable blunt ended tool inserted between the cushion and the handle push the handle retaining spring clip down.
    2. Pull the handle from the shaft.
    4. Fig 3: Side Trim Panel & Switch Harness
    GM71221Courtesy of GENERAL MOTORS CORP.
  4. Remove the side trim panel (power seat). Refer to Trim Panel Replacement - Front Seat .
    5. Fig 4: Rear Flap To Seat Cushion Cover
    GM172298Courtesy of GENERAL MOTORS CORP.
  5. Remove the hog-rings from the rear flap.
    6. Fig 5: Rear Corners At Seat Cushion Cover
    GM172293Courtesy of GENERAL MOTORS CORP.
  6. Raise the flap.
  7. Unfasten the draw string.
  8. Remove the hog-rings attaching the rear corners of the seat cushion trim cover.
  9. Remove the cover and foam pad.
  10. Remove the cover from the foam pad.
scientia non olet · About LEMON Manuals