LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1525 (Seat System) >> Repair Instructions >> Seat Cushion Frame Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  1. Remove the seat. Refer to Seat Replacement (Power)  or Seat Replacement (Manual) .
  2. Remove the buckle side of the seat belt from the seat frame.
    3. Fig 2: Seat Back Recliner Handle
    GM71223Courtesy of GENERAL MOTORS CORP.
  3. Remove the recliner handle.
    1. With a suitable blunt ended tool inserted between the seat cushion and the handle push the handle retaining spring clip down.
    2. Pull the handle from the shaft.
    4. Fig 3: Side Trim Panel & Switch Harness
    GM71221Courtesy of GENERAL MOTORS CORP.
  4. Remove the side trim panel (Power Seat). Refer to Trim Panel Replacement - Front Seat .
    5. Fig 4: Rear Flap To Seat Cushion Cover
    GM172298Courtesy of GENERAL MOTORS CORP.
  5. Remove the hog rings from the rear flap of the seat cushion cover.
    6. Fig 5: Rear Corners At Seat Cushion Cover
    GM172293Courtesy of GENERAL MOTORS CORP.
  6. Raise the flap.
  7. Unfasten the draw string.
  8. Remove the hogrings attaching the rear corners of the seat cushion cover.
  9. Remove the cover and foam pad.
  10. Remove the seat module from the seat wires (Base Power Seat).
    11. Fig 6: Lumbar Pump & Module To Seat Frame & Seat Back
    GM339492Courtesy of GENERAL MOTORS CORP.
  11. Remove the lumbar pump and module and pull them up through the seat frame and lay them aside still attached to the seat back (Sport Seat).
  12. Remove the memory module from the seat wires (Optional Sport Seat).
  13. Mark the seat back actuators to identify the right side from the left side.
  14. Note the routing of the recliner mechanism cables.
  15. Position the seat back full up to remove the tension from the actuator springs.
  16. Remove the forward pins from the seat back actuators.
    17. Fig 7: Actuators Underneath Seat Frame Springs
    GM71219Courtesy of GENERAL MOTORS CORP.
  17. Remove the hinge bolts.
  18. Remove the seat back.
  19. Reposition the actuators underneath the seat frame springs.
    20. Fig 8: View Of Seat Cushion Frame
    GM71217Courtesy of GENERAL MOTORS CORP.
  20. Remove the seat cushion frame from the seat adjuster.
  21. Remove the recliner mechanism from the seat cushion frame.
    22. Fig 9: Wire Assembly To Seat Cushion Frame
    GM281999Courtesy of GENERAL MOTORS CORP.
  22. Remove the wire assembly from the seat cushion frame (if replacing or transferring the wire assembly).
    1. Insert a screwdriver between the tension spring coils and pull toward the wires unhook the tension spring from the wire assembly.
    2. Unhook the wire assembly from the front of the seat cushion frame.
scientia non olet · About LEMON Manuals