Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not lubricate the seatback recliner mechanism.

Fig 1: Recliner Mechanism To Seat Frame

GM171527

Courtesy of GENERAL MOTORS CORP.

Install the recliner mechanism to the seat frame.
Install the cables to the actuators.
Securely snap the cable retaining clips to the actuators with the tabs up.

Fig 2: View Of Seat Cushion Frame

GM71217

Courtesy of GENERAL MOTORS CORP.

Install the seat adjusters to the seat if removed.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Apply Loctite™ 271 to the bolts and secure the adjuster to the seat.
Tighten: Tighten the bolts to 24 N.m (18 lb in).

Fig 3: Actuators Underneath Seat Frame Springs

GM71219

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use a tread locking compound on the hinge bolts.

Install the hinge bolts, seatback release cables, and nuts.
Tighten: Tighten the hinge bolt nuts to 24 N.m (18 lb ft).

Fig 4: Trim Cover To Seat Cushion Foam Pad

GM172296

Courtesy of GENERAL MOTORS CORP.

Install the seat cushion trim cover. Refer to Seat Cushion Trim Cover and Pad Replacement .

Fig 5: Switch To Side Trim Panel & Screws

GM281995

Courtesy of GENERAL MOTORS CORP.

Install the side trim panel. Refer to Trim Panel Replacement - Front Seat .

Fig 6: Recliner Handle To Reclining Mechanism Shaft

GM376637

Courtesy of GENERAL MOTORS CORP.

Install the recliner handle.
1. Position the handle retaining spring clip into the lock position.
2. Snap the handle onto the reclining mechanism shaft.

Fig 7: Seat Mounting Component View

GM71215

Courtesy of GENERAL MOTORS CORP.

Install the seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) .