LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1525 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  1. Remove the seat. Refer to Seat Replacement (Power)  or Seat Replacement (Manual) .
    2. Fig 2: Seat Adjuster Adjustment Bar
    GM281997Courtesy of GENERAL MOTORS CORP.
  2. For non-power seats, remove the adjuster adjustment bar.
    3. Fig 3: Rear Corners At Seat Cushion Cover
    GM172293Courtesy of GENERAL MOTORS CORP.
  3. Remove the seat cushion cover. Refer to Seat Cushion Trim Cover and Pad Replacement .
  4. Remove the seat cushion foam.
    5. Fig 4: Seat Electrical Connector
    GM71218Courtesy of GENERAL MOTORS CORP.
  5. Reposition the lumbar pump, if equipped.
  6. Remove the tie straps and reposition the pump and pouch up through the seat support wires.
  7. Remove the seat belt harness from the left seat frame.
  8. Remove the memory seat control module, if equipped.
    9. Fig 5: Buckle Side At Seat Belt
    GM63768Courtesy of GENERAL MOTORS CORP.
  9. Remove the buckle side of the seat belt.
    10. Fig 6: View Of Seat Cushion Frame
    GM71217Courtesy of GENERAL MOTORS CORP.
  10. Remove the hardware mounting the seat to the adjuster:
    • For a design 1 vehicle, remove the bolts.
    • For a design 2 vehicle, remove the nuts.
  11. Remove the adjuster.
  12. Transfer the parts as necessary.
scientia non olet · About LEMON Manuals