Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Seat Cushion Frame

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the adjuster to the seat. Tighten the hardware to the seat:
Tighten:
- For a design 1 vehicle, tighten the adjuster bolts to 24 N.m (18 lb ft).
- For a design 2 vehicle, tighten the adjuster nuts to 24 N.m (18 lb ft).

Fig 2: Seat Adjuster Adjustment Bar

Courtesy of GENERAL MOTORS CORP.

For non-power seats, align the adjusters with their locking pawls engaged in the same slots side to side.
Install the seat adjuster adjustment bar.

Fig 3: Lumbar Pump & Module To Seat Frame & Seat Back

Courtesy of GENERAL MOTORS CORP.

Install the lumbar pump, if equipped.
Tie strap the pump to the torque tube.
Connect the seat belt harness to the left seat.

Fig 4: Wire Assembly To Seat Cushion Frame

Courtesy of GENERAL MOTORS CORP.

Install the memory seat control module to the seat spring wire, if equipped.

Fig 5: Trim Cover To Seat Cushion Foam Pad

Courtesy of GENERAL MOTORS CORP.

Install the foam to the seat frame.
Install the seat cushion cover. Refer to Seat Cushion Trim Cover and Pad Replacement .

Fig 6: Buckle Side At Seat Belt

Courtesy of GENERAL MOTORS CORP.

Install the buckle side of the seat belt.
Tighten: Tighten the mounting nut to 50 N.m (37 lb ft).

Fig 7: Seat Mounting Component View

Courtesy of GENERAL MOTORS CORP.

Install the seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) .
If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure .