LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1525 (Seat System) >> Repair Instructions >> Seat Adjuster Motor Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Electrical Connector
    GM71218Courtesy of GENERAL MOTORS CORP.
  1. Position the motors and harness to the seat frame.
  2. Install the cables to the two rear motors and to the adjuster.
  3. Install the screws mounting the rear motors.
  4. Install the front motor (forward and back motor) to the bracket.
  5. Connect the harness electrical connector.
  6. Position the bracket onto one adjuster transmission.
  7. Insert the drive cable into the motor and then into the transmission. It may be necessary to turn the cable to get the cable to slide into the transmission.
  8. Repeat the 2 previous steps on the opposite side.
  9. Bend the bracket ends outward enough to prevent the bracket from sliding off the transmissions.
    10. Fig 2: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  10. Tie strap the lumbar pump to the torque tube, if equipped.
  11. Install the seat. Refer to Seat Replacement (Power)  or Seat Replacement (Manual) .
  12. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure .
scientia non olet · About LEMON Manuals