Memory Seat Switch Indicator Malfunction
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Memory Seat Switch Indicator Malfunction
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Door Control Module Schematics DEFINITION: The memory 1 or 2 select indicators are inoperative or always on. |
|||
| 1 | Did you perform the Power Seat Systems Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Power Seat Systems |
| 2 | Verify the fault is present. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Is the malfunctioning indicator always on? | Go to Step 4 | Go to Step 5 |
| 4 | Test the appropriate memory select indicator control circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 5 |
|
Go to Step 7 | Go to Step 6 |
| 6 | Test the appropriate memory select indicator control circuit for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 7 | Inspect for poor connections at the LH door switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 8 |
| 8 | Replace the LH door switch. Refer to Front Door Switch Replacement
in Doors. Is the repair complete? |
Go to Step 11 | - |
| 9 | Inspect for poor connections at the LH door control module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 10 | Replace the LH door control module. Refer to Door Control Module Replacement
in Doors. Is the repair complete? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |