LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Wheelhouse Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Wheelhouse Liner Panel
    GM71250Courtesy of GENERAL MOTORS CORP.
  1. Position the wheelhouse liner panel.
  2. Install the upper outer bolt.
  3. Install the upper center bolts.
  4. Position the lower front corner of the wheelhouse liner panel behind the door opening finish panel and install the attaching bolt.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the remaining bolts attaching the wheelhouse liner panel to the wheelhouse.

    Tighten:  Tighten the rear wheelhouse liner bolts to 2 N.m (18 lb in).

  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
scientia non olet · About LEMON Manuals