LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Roof Lift Off Panel Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Roof Bow & Lock Pillar At Side Retainer
    GM214130Courtesy of GENERAL MOTORS CORP.
  1. Apply a 6 mm (0.25 in) X 100 mm (4 in) bead of thumb grade sealer to the roof bow and lock pillar overlapping the side retainer as shown.
    2. Fig 2: Weatherstrip At Side & Center Retainer
    GM71246Courtesy of GENERAL MOTORS CORP.
  2. Peel the protective film from the foam tape on the new weatherstrip, or install two sided tape to a reused weatherstrip.
  3. Position the rear roof weatherstrip to the retainers on the roof bow.
  4. Insert the weatherstrip into the center retainer working from the center outward.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the screws into the upper corners of the rear weatherstrip.

    Tighten:  Tighten the roof weatherstrip upper corner screws to 3 N.m (27 lb in).

  6. Insert the rear weatherstrip into the side retainers starting at the upper corners and working downward.
  7. Install the push in fasteners at the lower ends of the rear weatherstrip.
    8. Fig 3: Sunroof View
    GM63735Courtesy of GENERAL MOTORS CORP.
  8. Install the roof panel.
scientia non olet · About LEMON Manuals