LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Rear Lift Window Panel >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Weatherstrip At Panel
    GM476333Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear compartment lift window panel and place the panel on a clean flat protective surface. Refer to Lift Window Panel Replacement - Rear .
  2. Remove the weatherstrip.

    Pull the weatherstrip from the panel.

  3. Remove the old weatherstrip retaining spring clips if replacing the clips.
  4. Clean the panel surface removing all traces of the old weatherstrip.