LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Support Brace Replacement - Rear Compartment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Compartment Brace At Floor Studs
    GM71253Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the brace and attaching nuts to the floor panel studs.

    Tighten:  Tighten the rear compartment brace to floor nuts to 10 N.m (89 lb in).

  2. Install the fuel system vent, (right brace only).
    3. Fig 2: Quarter Panel To The Rear Compartment Brace
    GM63719Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts attaching the quarter panel to the rear compartment brace.

    Tighten:  Tighten the quarter panel to rear compartment brace bolts to 5 N.m (44 lb in).

    4. Fig 3: Rear Wheelhouse Liner Panel
    GM71250Courtesy of GENERAL MOTORS CORP.
  4. Install the wheelhouse liner panel. Refer to Wheelhouse Panel Replacement .
scientia non olet · About LEMON Manuals