LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Strut Replacement - Rear Lift Window Panel >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lift Window Panel And Suitably
    GM71238Courtesy of GENERAL MOTORS CORP.
  1. Open and support the rear lift window panel.
    2. Fig 2: Upper Defogger Connection At Strut
    GM71233Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the lower rear defogger electrical connector from the strut.
  3. Reposition the retaining clip outward from the struts lower ball socket using a small flat-bladed tool.
  4. Pull the strut from the lower ball stud.
    5. Fig 3: Strut At Upper Ball Stud
    GM71271Courtesy of GENERAL MOTORS CORP.
  5. Reposition the retaining clip outward from the struts upper ball socket.
  6. Disconnect the electrical connector from the upper end of the strut.
  7. Remove the strut from the upper ball stud.
scientia non olet · About LEMON Manuals