LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Latch Replacement - Rear Lift Window Panel >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, the rear compartment lift window panel may be manually released by pulling on the manual release cables located behind the cargo compartment rear corner carpet panels. Access the cables through the slots in the corner carpet panels.

    Fig 1: Rear Floor Side Stowage Compartment Cover
    GM193338Courtesy of GENERAL MOTORS CORP.
  1. Open the rear compartment lift window panel.
  2. Remove the rear floor side stowage compartment cover.
    3. Fig 2: View Of Cargo Lamp Assembly
    GM64673Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear/end corner carpet trim panel. Refer to Trim Panel Carpet Replacement - Rear Corner (Coupe) or Trim Panel Carpet Replacement - Rear Corner (Convertible) or Trim Panel Carpet Replacement - Rear Corner (Hardtop) in Interior Trim.
  4. Slide the cargo lamp up out of the trim panel.
    5. Fig 3: Electrical Harness At Latch
    GM71241Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical harness from the latch.
  6. Remove the bolts attaching the latch.
  7. Remove the latch.
scientia non olet · About LEMON Manuals