Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Latch At Latch Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts attaching the latch to the latch bracket.
Tighten: Tighten the rear compartment lid latch bolts to 10 N.m (89 lb in).
Route the manual release cable down to the rear center floor stowage compartment.
Connect the electrical harness connector.
Install the rear center carpet panel.