LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Latch Bracket Replacement - Rear Lift Window Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Latch With Bracket At Rear Body Panel
    GM71243Courtesy of GENERAL MOTORS CORP.
  1. Position the latch with bracket to the rear body panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts attaching the latch bracket.

    Tighten:  Tighten the latch bracket mounting nuts to 10 N.m (89 lb in).

  3. Connect the electrical harness.
    4. Fig 2: Center And Drivers Side Rear Floor Stowage Compartment Covers
    GM71198Courtesy of GENERAL MOTORS CORP.
  4. Install the rear/end corner carpet trim panel. Refer to Trim Panel Carpet Replacement - Rear Corner (Coupe) or Trim Panel Carpet Replacement - Rear Corner (Convertible) or Trim Panel Carpet Replacement - Rear Corner (Hardtop) in Interior Trim.
  5. Install the rear floor side stowage compartment cover.
  6. Install the taillamps.

    Tighten:  Tighten the taillamp mounting screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals