LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Hinge Replacement - Rear Lift Window Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hinge At Lift Window Panel
    GM71239Courtesy of GENERAL MOTORS CORP.
  1. Position the hinge to the lift window panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts attaching the hinge to the lift window panel.

    Tighten:  Tighten the lift window hinge bolts to 25 N.m (18 lb ft).

    3. Fig 2: Lift Window Panel And Suitably
    GM71238Courtesy of GENERAL MOTORS CORP.
  3. Apply sealer around the hinge studs.
  4. Install the rear compartment lift window panel. Refer to Lift Window Panel Replacement - Rear .
scientia non olet · About LEMON Manuals