Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hinges At Lid & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts attaching the hinge to the lid.
Tighten: Tighten the rear compartment hinge to lid bolts to 31 N.m (23 lb ft).
Install the bolts attaching the hinge to the body.
Tighten: Tighten the rear compartment hinge to body bolts to 25 N.m (18 lb ft).
Remove support and lower lid.