LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Fuel Filler Door Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Door At Inner Body Pane
    GM71229Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the fuel filler door in an open position to the fuel pocket.
  2. Install the bolt attaching the door to the inner panel.

    Tighten:  Tighten the fuel filler door bolt to 2 N.m (18 lb in).

    3. Fig 2: Fuel Filler Door At Quarter Panel
    GM71225Courtesy of GENERAL MOTORS CORP.
  3. Install the screws attaching the fuel filler door to the quarter panel.

    Tighten:  Tighten the filler door to quarter panel screws to 2 N.m (18 lb in).

  4. Install the fuel cap retaining strap.
scientia non olet · About LEMON Manuals