LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Fuel Filler Door Release Actuator Replacement (Convertible) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Door Release Cable At Pocket
    GM71227Courtesy of GENERAL MOTORS CORP.
  1. Position the actuator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut attaching the actuator.

    Tighten:  Tighten the fuel filler door release actuator nut to 2 N.m (18 lb in).

  3. Connect the electrical connection.
  4. Install the cable to the fuel pocket.
  5. Install the nut attaching the fuel filler door release cable to the fuel filler pocket.

    Tighten:  Tighten the fuel filler door release cable nut to 3 N.m (27 lb in).

    6. Fig 2: Rear Wheelhouse Liner Panel
    GM71250Courtesy of GENERAL MOTORS CORP.
  6. Install the wheelhouse liner panel with the upper outer bolt.
  7. Install the remaining upper bolts.
  8. Position the lower front corner of the wheelhouse liner panel behind the door opening finish panel and install the attaching bolt.
  9. Install the remaining bolts attaching the wheelhouse liner panel.

    Tighten:  Tighten the wheelhouse liner panel bolts to 2 N.m (18 lb in).

  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    11. Fig 3: Trim Panel At Rear Compartment
    GM214021Courtesy of GENERAL MOTORS CORP.
  11. Reposition the rear floor carpet over the wheelhouse.
  12. Install the stowage compartment support trim panel.
    13. Fig 4: Rear Side Trim Panel
    GM214022Courtesy of GENERAL MOTORS CORP.
  13. Install the side trim panel.
scientia non olet · About LEMON Manuals