LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Compartment Lid Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hinges At Lid & Bolts
    GM214000Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, position the lid to the hinges aligning the hinges with the marks on the lid.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts attaching the hinges to the lid.

    Tighten:  Tighten the rear compartment to lid hinge bolts to 31 N.m (23 lb ft).

  3. Remove the lid support and the protective cover.
    4. Fig 2: Overslam Bumpers
    GM213995Courtesy of GENERAL MOTORS CORP.
  4. Install and adjust the overslam bumpers.
    5. Fig 3: Forward Edge At Lid To The Adjacent Panel
    GM444624Courtesy of GENERAL MOTORS CORP.
  5. Check the flushness of the forward edge of the lid to the adjacent panel.
  6. Adjust the alignment bumper as necessary to make the forward edge of the lid flush to the adjacent panel.
scientia non olet · About LEMON Manuals