LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1523 (Body Rear End) >> Repair Instructions >> Brake Caliper Cooling Duct Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Cooling Air Scoop
    GM721304Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper cooling air scoop.
    2. Fig 2: Brake Caliper Cooling Air Scoop Nuts
    GM721302Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 brake caliper cooling air scoop nuts.

    Tighten:  Tighten the brake caliper cooling air scoop nuts to 3 N.m (27 lb in).

    3. Fig 3: Wheelhouse Panel & Brake Caliper Cooling Duct
    GM721300Courtesy of GENERAL MOTORS CORP.
  3. Install the brake caliper cooling duct.
  4. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals