LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1522 (Horn System) >> Repair Instructions >> Horn Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Horn Assembly Electrical Connector
    GM65137Courtesy of GENERAL MOTORS CORP.
  1. Remove the right front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  2. Disconnect the horn assembly electrical connector.
    3. Fig 2: Horn Assembly At Skid Bar
    GM65138Courtesy of GENERAL MOTORS CORP.
  3. Remove the horn assembly bolt.
  4. Remove the horn assembly from the skid bar.
scientia non olet · About LEMON Manuals