LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1522 (Horn System) >> Diagnostic Information and Procedures >> Horns Always On >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The number(s) below refer to the step number(s) on the diagnostic table.

  1. 4:  Tests if ground is constantly being applied to the horn relay.
  2. 5:  The horn relay control circuit includes the horn slip ring and the horn switch. The horn slip ring and the horn switch must be tested for a short to ground when testing the relay control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Horns Always On

Step Action Yes No
1 Did you perform the Horns Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Horns 
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, command the body control module (BCM) Horn Output ON and OFF.
Are the horns on at all times?		 Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Turn OFF the ignition.
  2. Disconnect the horn relay.
Are the horns on at all times?		 Go to Step 8  Go to Step 4 
4  Connect a test lamp between the battery positive voltage circuit of the horn relay coil and the horn relay control circuit.
Does the test lamp illuminate?		 Go to Step 5  Go to Step 6 
5  Test the horn relay control circuit for a short to ground. (The horn relay control circuit includes the horn slip ring and the horn switch.) Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 7 
6 Inspect for poor connections at the horn relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 9 
7 Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 10 
8 Repair the short to voltage in the horn control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 11  -
9 Replace the horn relay.
Did you complete the replacement?		 Go to Step 11  -
10
IMPORTANT: Perform the BCM programming procedure when replacing the BCM.
Replace the BCM. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?		 Go to Step 11  -
11 Operate the horns.
Do the horns operate properly?		 System OK Go to Step 1 
scientia non olet · About LEMON Manuals