Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Remove the door lock striker cover. Pull the cover loose from the hook and loop fastener patches.

Fig 1: Striker Cover At Fastener Patches
Courtesy of GENERAL MOTORS CORP.
Mark the location of the door lock striker.
Remove the door lock striker and shims.

Fig 2: Lock Pillar Trim Panel (Coupe, Hardtop)

Courtesy of GENERAL MOTORS CORP.

Remove the lock pillar trim panel. Refer to Trim Replacement - Lock Pillar (Upper Convertible) or Trim Replacement - Lock Pillar (Coupe) or Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) in Interior Trim.

Fig 3: Lock Pillar Inner Trim Panel Upper Clip Slot At Lock Pillar (Coupe, Hardtop)

Courtesy of GENERAL MOTORS CORP.

Cut a 51 mm (2 in) access hole with a hole saw using the 3.6 mm (1/8 in) hole (1) located 24 mm (1 in) below the lock pillar inner trim panel upper clip slot on the lock pillar as a locator. The 3.6 mm (1/8 in) hole is located about 127 mm (5 in) higher than the striker on the inner upper surface of the lock pillar.

Fig 4: Upper Tab At Nut Plate Retaining Bracket (Coupe, Hardtop)

Courtesy of GENERAL MOTORS CORP.

Bend out the upper tab on the nut plate retaining bracket.

Fig 5: Nut Plate At Retaining Bracket (Coupe, Hardtop)

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: When removing and installing the nut plate be extremely careful to securely hook the nut plate to prevent dropping the plate into the pillar resulting in a vehicle rattle.

Hook the nut plate with a stiff wire and carefully pull the nut plate up and out of the retaining bracket and out through the access hole.