LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1519 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Adjustment - Front >> In/Out Adjustment Procedure

In/Out Adjustment Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Loosen one set of hinge bolts at a time and move the hinge not the door be sure to retighten the hinge bolts before loosing and adjusting the other hinge.
    Fig 1: Upper Hinge At Door Bolts
    GM63779Courtesy of GENERAL MOTORS CORP.
  1. Loosen the upper hinge to door bolts.
  2. Reposition the hinge outward to adjust the door inward or inward to adjust the door outward.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the upper hinge to door bolts.

    Tighten:  Tighten the door hinge to door bolts to 30 N.m (22 lb in).

  4. Loosen the lower hinge to door bolts.
  5. Reposition the hinge.
  6. Tighten the lower hinge to door bolts.

    Tighten:  Tighten the door hinge to door bolts to 30 N.m (22 lb in).

  7. Repeat procedure for additional adjustment if necessary.
scientia non olet · About LEMON Manuals