Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Screw At Lock Pillar Upper Trim

Courtesy of GENERAL MOTORS CORP.

Install the lock pillar upper trim.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screw securing the upper trim to the lock pillar.
Tighten: Tighten the lock pillar upper trim screw to 1.8 N.m (16 lb in).
Install the spacer and washer to the seat belt guide stud.

Fig 2: Seatbelt Upper Guide To Stud

Courtesy of GENERAL MOTORS CORP.

Install the upper seat belt guide.
Tighten: Tighten the upper guide nut to 40 N.m (29 lb ft).