LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1518 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Compartment Front Side (Hardtop) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Compartment Side Trim Panels
    GM376653Courtesy of GENERAL MOTORS CORP.
  1. Position the side trim panel to the vehicle.
  2. Secure the panel to the roof bow.
  3. Secure the side trim panel to the lock pillar.
  4. Secure the side trim panel to the rear compartment support with a push in retainer.
  5. Secure the side trim panel to the side of the roof.
    6. Fig 2: Seat Belt Upper Guide Bolt
    GM63763Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the seat belt upper guide bolt and cover.

    Tighten:  Tighten the seat belt guide bolt to 41 N.m (31 lb ft).

  7. Snap the cover closed.
    8. Fig 3: Trim Panels To Rear Compartment Supports
    GM426783Courtesy of GENERAL MOTORS CORP.
  8. Install the rear compartment support trim panel.
    9. Fig 4: Garnish Molding To Roof Panel
    GM376650Courtesy of GENERAL MOTORS CORP.
  9. Align the rear window lower garnish molding retainers to the holes in the roof panel.
  10. Push firmly on the garnish molding seating the retainers.
  11. Install the push pins securing the ends of the garnish molding.
scientia non olet · About LEMON Manuals