Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Speaker Grille To Side Trim Panel

Courtesy of GENERAL MOTORS CORP.

Position the side trim panel to the lock pillar.
Secure the panel with the push-in fastener and hook and loop fasteners.
Install the fir tree push-in retainer to the rear of the speaker grill opening.
Insert the lower tab of the grille into the opening and snap the grille in place.

Fig 2: Seat Belt Upper Guide Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the seat belt guide bolt and cover.
Tighten: Tighten the seat belt guide bolt to 46 N.m (34 lb ft).

Fig 3: View Of Strut

Courtesy of GENERAL MOTORS CORP.

Install the strut. Refer to Strut Replacement - Rear Lift Window Panel in Body Rear End.

Fig 4: Fasteners At Rear Roof Bow Weatherstrip To Lock Pillar

Courtesy of GENERAL MOTORS CORP.

Install the push-in fasteners attaching the weatherstrip to the lock pillar.

Fig 5: Rear Roof Bow Interior Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the rear roof bow interior trim panel and the roof lift off panel. Refer to Trim Panel Replacement - Rear Roof Bow .
Remove the support and close the lift window.