LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1518 (Interior Trim) >> Repair Instructions >> Mounting Plate - Roof Lift Off Panel Front Stowage >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Roof Front Stowage Bracket Mounting Plate
    GM457568Courtesy of GENERAL MOTORS CORP.
  1. Position the mounting plate to the rear compartment floor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts attaching the mounting plate.
    1. Install the rear inboard bolt first.
    2. Install the rear outboard bolt second.
    3. Install the forward bolt third.

      Tighten:  Tighten the roof stowage bracket mounting plate bolts to 8 N.m (71 lb in).

    3. Fig 2: Corner Carpet Trim Panels
    GM71198Courtesy of GENERAL MOTORS CORP.
  3. Install the floor carpeting. Refer to Carpet Replacement - Rear Compartment Floor (Convertible)  or Carpet Replacement - Rear Compartment Floor (Coupe)  or Carpet Replacement - Rear Compartment Floor (Hardtop) .
    4. Fig 3: Bezel To Ribs On Mounting Plate & Stowage Bracket
    GM63751Courtesy of GENERAL MOTORS CORP.
  4. Snap the bezel onto the ribs on the mounting plate. Press firmly around the entire periphery of the bezel.
  5. Install the stowage bracket. Rotate the egg shaped bracket 90 degrees counterclockwise to secure the bracket.
scientia non olet · About LEMON Manuals