Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the headlining to the vehicle.
- Support the headlining.
- Install the retainer securing the rear edge of the headlining.
- Route the sunshade electrical connection through the headlining and the sunshade bezel.
- Install the sunshade bezels.
Insert the bezel into the opening until the snap fingers engage.
- Install the sunshades. Refer to Sunshade Replacement .
- Install the sunshade retainers.
Tighten: Tighten the screws to 2 N.m (17 lb in).
- Remove the headlining temporary support.
- Install the windshield side garnish moldings. Refer to Windshield Side Garnish Molding Replacement .
- Install the trim panels to the front side of the rear compartment. Refer to Trim Panel Replacement - Rear Compartment Front Side (Convertible) or Trim Panel Replacement - Rear Compartment Front Side (Hardtop) or Trim Panel Replacement - Rear Compartment Front Side (Coupe) .
- Reposition the inside lip of the upper weatherstrips on the door window over the edge of the headlining.
CAUTION:
Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.
NOTE:
Refer to Fastener Notice in Cautions and Notices.