Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical/Audio Connector At Rear Speaker & Screws

Courtesy of GENERAL MOTORS CORP.

Connect the electrical/audio connector to the rear speaker.
Install the rear speaker into position.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear speaker retaining screws.
Tighten: Tighten the rear speaker retaining screws to 2.5 N.m (22 lb in).
Install the rear compartment side trim panel. Refer to Trim Panel Replacement - Rear Compartment Front Side (Convertible) or Trim Panel Replacement - Rear Compartment Front Side (Hardtop) or Trim Panel Replacement - Rear Compartment Front Side (Coupe) in Interior Trim.