Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical/Audio Connector At Rear Speaker

Courtesy of GENERAL MOTORS CORP.

Connect the electrical/audio connector to the rear speaker.
Install the rear speaker into position.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear speaker retaining screws.
Finesse the rear compartment side trim panel carefully upward, rearward and outward slightly to access the upper speaker retaining screw.

Tighten: Tighten the rear speaker retaining screws to 2.5 N.m (22 lb in).

Fig 2: Push -In Fastener At Rear Compartment Speaker Grille

Courtesy of GENERAL MOTORS CORP.

Install the push -in fastener (in the lower corner of the speaker opening) retaining the rear compartment side trim panel.
Insert the rear speaker grille lower retaining tab into position.
Raise the speaker grille and align the locking tabs.
Carefully push the tabs in to lock.
Close the rear lift window panel.