Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Coaxial Extension Cable At Antenna Module

Courtesy of GENERAL MOTORS CORP.

Install the rear lift window antenna coaxial extension cable push -in fastener retainers to the front seat back reinforcement panel and along the lock pillar.
Connect the coaxial extension cable to the antenna module.

Fig 2: Rear Lift Window Antenna Coaxial Extension Cable At Antenna Buffer

Courtesy of GENERAL MOTORS CORP.

Working upward along the roof bow, install the remaining coaxial extension cable push -in fastener retainers.
Connect the coaxial extension cable to the antenna buffer.
Install the lock pillar trim panel. Refer to Trim Replacement - Lock Pillar (Upper Convertible) or Trim Replacement - Lock Pillar (Coupe) or Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) in Interior Trim.
Install the rear compartment side trim panel. Refer to Trim Panel Replacement - Rear Compartment Front Side (Convertible) or Trim Panel Replacement - Rear Compartment Front Side (Hardtop) or Trim Panel Replacement - Rear Compartment Front Side (Coupe) in Interior Trim.
Install the roof bow interior trim panel. Refer to Trim Panel Replacement - Rear Roof Bow in Interior Trim.