Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector to the inside air temperature sensor, if equipped.
- Insert the electrical connector for the fog lamp, rear compartment lid release switch through the opening in the trim panel.
- Install the driver knee bolster trim panel.
- If equipped, insert the inside air temperature sensor wire down into the driver knee bolster bracket to avoid pinching the wire.
- Align the locking tabs to the slots.
- Push the trim panel to secure.
- Loosely install the screws retaining the bottom of the driver knee bolster trim panel, in order to align the nuts on the knee bolster bracket.
- Install the remaining driver knee bolster trim panel retaining screw.
Tighten:
- Tighten the driver knee bolster trim panel retaining screw behind fog lamp, rear compartment lid release switch to 1.8 N.m (16 lb in).
- Tighten the driver knee bolster trim panel lower retaining screws to 1.8 N.m (16 lb in).
- Install the fog lamp, rear compartment lid release switch.
- Connect the electrical connector to the switch.
- Align the switch, then push to secure.
- Install the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
- Install the console. Refer to Console Replacement .
NOTE:
Refer to Fastener Notice in Cautions and Notices.