LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1516 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: IPC Electrical Connector
    GM95721Courtesy of GENERAL MOTORS CORP.
  1. Connect the instrument panel cluster (IPC) electrical connector.
    2. Fig 2: IPC At Steering Column Bracket
    GM95728Courtesy of GENERAL MOTORS CORP.
  2. Position the IPC to the steering column bracket.
  3. Check that the IPC retaining tab (1) is positioned correctly to the steering column bracket (2).
    4. Fig 3: IPC To Steering Column Bracket Retaining Screws
    GM95727Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the IPC to steering column bracket retaining screws.

    Tighten:  Tighten the IPC to steering column bracket retaining screws to 3 N.m (27 lb in).

    5. Fig 4: HUD Electrical Connector To IPC
    GM378944Courtesy of GENERAL MOTORS CORP.
  5. Connect the head-up display (HUD) electrical connector to the IPC, if equipped.
  6. Carefully tuck the HUD electrical harness (1) down between the IPC and the HUD as shown, if equipped.
  7. Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
  8. Connect the negative battery cable.

    Tighten:  Tighten the negative battery cable bolt to 15 N.m (11 lb ft).

  9. Program the transmitters. Refer to Transmitter Programming in Keyless Entry.
  10. Synchronize the transmitters. Refer to Transmitter Resynchronization in Keyless Entry.
scientia non olet · About LEMON Manuals