LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1516 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Head Up Display Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to IPC Servicing Notice in Cautions and Notices.
  1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to Instrument Panel Cluster (IPC) Replacement .
  2. Disconnect the instrument panel (IP) dimmer/head-up display (HUD) switch electrical connector.
    Fig 1: Instrument Panel Dimmer/HUD Switch Electrical Connector
    GM95725Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Driver Information Center (DIC) Switch Electrical Connector
    GM95726Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the driver information center (DIC) switch electrical connector.
    4. Fig 3: IP Cluster Bezel To IPC
    GM95724Courtesy of GENERAL MOTORS CORP.
  4. Remove the IP cluster bezel retaining screws.
  5. Remove the bezel from the IPC.
    6. Fig 4: IP Dimmer/HUD Switch To IP Cluster Bezel
    GM95722Courtesy of GENERAL MOTORS CORP.
  6. Remove the IP dimmer/HUD switch retaining screws.
  7. Remove the IP dimmer/HUD switch.
scientia non olet · About LEMON Manuals