LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1516 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Head Up Display Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
  3. Carefully lift the head-up display (HUD) electrical harness from between the instrument panel cluster (IPC) and the HUD.
    Fig 1: HUD Electrical Connector At IPC
    GM378941Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the HUD electrical connector from the IPC.
    5. Fig 2: IPC To Steering Column Bracket Retaining Screws
    GM95727Courtesy of GENERAL MOTORS CORP.
  5. Remove the IPC to steering column bracket retaining screws.
  6. Raise the rear of the IPC slightly to release the locator tab, then reposition the IPC to access the HUD-to-steering column bracket retaining screw.
    7. Fig 3: HUD-To-Steering Column Bracket
    GM378935Courtesy of GENERAL MOTORS CORP.
  7. LOOSEN the HUD-to-steering column bracket retaining screw.
  8. Remove the HUD retaining nuts.
  9. Remove the HUD from the vehicle.
scientia non olet · About LEMON Manuals