LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1516 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Knee Bolster (Driver Outer) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Driver Knee Bolster Outer Bracket To Steering Column Bracket
    GM95667Courtesy of GENERAL MOTORS CORP.
  1. Install the outer driver knee bolster bracket into position as marked prior to removal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the driver knee bolster outer bracket to steering column bracket retaining screws.

    Tighten:  Tighten the driver knee bolster outer bracket retaining screws to 1.9 N.m (17 lb in).

  3. Install the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  4. Install the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
  5. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals