Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: DIC Switch To I/P Cluster Bezel

Courtesy of GENERAL MOTORS CORP.

Install the DIC switch to the I/P cluster bezel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the DIC switch retaining screws.
Tighten: Tighten the DIC switch retaining screws to 1.5 N.m (13 lb in).

Fig 2: IP Dimmer/HUD Switch To IP Cluster Bezel

Courtesy of GENERAL MOTORS CORP.

Install the I/P dimmer switch or I/P dimmer/HUD switch to the bezel.
Install the I/P dimmer switch or I/P dimmer/HUD switch retaining screws.
Tighten: Tighten the I/P dimmer switch or I/P dimmer/HUD switch retaining screws to 1.5 N.m (13 lb in).

Fig 3: IP Cluster Bezel To IPC

Courtesy of GENERAL MOTORS CORP.

Install the bezel to the IPC.
Align the bezel onto the guide pins.
Install the I/P cluster bezel retaining screws.
Tighten: Tighten the I/P cluster bezel retaining screws to 1.5 N.m (13 lb in).

Fig 4: Instrument Panel Dimmer/HUD Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the I/P dimmer switch or I/P dimmer/HUD switch electrical connector.

Fig 5: Driver Information Center (DIC) Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the DIC switch electrical connector.
Install the IPC to the vehicle. Refer to Instrument Panel Cluster (IPC) Replacement .