LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1514 (Manual Transmission Clutch System) >> Repair Instructions >> Release Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Clutch Release Bearing
    GM71484Courtesy of GENERAL MOTORS CORP.
  1. Remove the driveline support assembly and the transaxle from the vehicle (with the clutch actuator cylinder). Refer to Driveline Support Assembly Replacement (Automatic Transmission) or Driveline Support Assembly Replacement (Manual Transmission) in Propeller Shaft.
  2. Remove the clutch release bearing.

    Rotate the bearing in either direction.

    The compression spring load will push the release bearing off the end of the clutch actuator cylinder.

scientia non olet · About LEMON Manuals