Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Pedal Position Switch & Clutch Pedal Bracket

Courtesy of GENERAL MOTORS CORP.

Install the clutch pedal position switch (clutch start switch) to the clutch pedal bracket.
Insert the switch locators into the top of the slots, then slide down to lock.

Fig 2: Clutch Pedal Position Switch & Clutch Start Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the switch electrical connector.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Connect the negative battery cable.
Tighten: Tighten the negative battery cable bolt to 15 N.m (11 lb ft).
Program the transmitters. Refer to Transmitter Programming in Keyless Entry.