Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the left I/P lower insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
- Remove the clutch master cylinder rod retainer.
- Remove the clutch master cylinder rod from the clutch pedal.
- Remove the windshield washer solvent container. Refer to Washer Solvent Container Replacement in Wipers/Washer Systems.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the clutch actuator cylinder hose from the hose retaining clip, at the rear of the engine.
- Using the J 36221 , depress the white circular release ring on the actuator hose and simultaneously pull lightly on the master cylinder hose to disconnect.
- Protect both hose coupling ends from dirt and damage.
- Lower the vehicle. Leave the vehicle on the hoist.
- Remove the clutch master cylinder reservoir push-in fasteners.
- Rotate the clutch master cylinder clockwise 45 degrees.
- Release the clutch master cylinder from the dash panel.
- Remove the clutch master cylinder and reservoir from the vehicle.
CAUTION:
Refer to Battery Disconnect Caution
in Cautions and Notices.