Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lamp At Fascia To Tail & Turn Signal Lamp Sockets

Courtesy of GENERAL MOTORS CORP.

Install the bulbs to the lamp sockets, if replacing the bulbs.
Install the sockets to the lamp assembly.
Position the tail/turn signal lamp assembly to the rear fascia.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the tail/turn signal lamp screws to the rear fascia.
Tighten: Tighten the tail/turn signal lamp screws to 2 N.m (18 lb in).