LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1513 (Lighting Systems) >> Repair Instructions >> Repeater Lamp Replacement (Europe Japan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Side Repeater Lamp Socket To Front Side Repeater Lamp Assembly
    GM95535Courtesy of GENERAL MOTORS CORP.
  1. Position the front side repeater lamp to the fender.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the front side repeater lamp retaining nuts.

    Tighten:  Tighten the front side repeater lamp retaining nuts to 2 N.m (18 lb in).

  3. Install the socket to the lamp assembly.
  4. Install the wheelhouse filler panel. Refer to Wheelhouse Filler Replacement in Body Front End.
scientia non olet · About LEMON Manuals