LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1513 (Lighting Systems) >> Repair Instructions >> Position Lamp Bulb Replacement (Europe Japan) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Cooling Duct To Front Fascia
    GM171878Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, and position aside.
    4. Fig 2: Front Position Lamp Socket To Lamp Assembly
    GM95540Courtesy of GENERAL MOTORS CORP.
  4. Open the lamp access door on top of the front fascia closeout.
  5. Remove the front position lamp socket from the lamp assembly.
  6. Remove the bulb from the socket.
scientia non olet · About LEMON Manuals