Headlamp Opening Door Adjustment

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Headlamp Opening Door To The Hood At Fender & Front Fascia

Courtesy of GENERAL MOTORS CORP.

Remove the headlamp opening door. Refer to Headlamp Opening Door Replacement .
For horizontal adjustment:
1. Loosen the headlamp intermediate bracket to headlamp assembly screws (1).
2. Adjust the position of the headlamp intermediate bracket (3) as required and retighten the retaining screws (1).
  NOTE: Refer to Fastener Notice in Cautions and Notices.
  
  Tighten: Tighten the headlamp intermediate bracket screws to 2 N.m (18 lb in).
For vertical adjustment:
Tighten (to lower) or loosen (to raise) the vertical adjusting screws (2) as needed.
For headlamp opening door stop position adjustment, if necessary:
Tighten or loosen the door stop adjustment screw as needed.
Install the headlamp opening door. Refer to Headlamp Opening Door Replacement .
Inspect the fit of the headlamp opening door to the hood, the fender and the front fascia.
If the fit of the headlamp opening door is unsatisfactory, repeat steps 2 through 7.