LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1513 (Lighting Systems) >> Repair Instructions >> Daytime Running Lamps (DRL) Ambient Light Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector To DRL Sensor
    GM64706Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the DRL sensor.
  2. Twist to secure the DRL sensor to the defroster grille.
  3. Position the tabs along the front edge of the defroster grille down into the slots in the upper trim pad.
  4. Lower the rear edge of the defroster grille into position, then CAREFULLY press the rear tabs into place.
scientia non olet · About LEMON Manuals