LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1513 (Lighting Systems) >> Diagnostic Information and Procedures >> Headlamps Inoperative - Low and High Beams

Headlamps Inoperative - Low and High Beams

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Headlamps Inoperative - Low and High Beams

Step Action Yes No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics 
Connector End View Reference: Master Electrical Component List
1 Did you perform the Lighting System Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2
  1. Turn the ignition to the ON position.
  2. Cover the ambient light sensor with a dark cloth.
Do the low beam headlamps illuminate?		 Go to Step 3  Go to Twilight Sentinel Inoperative 
3
  1. Turn the headlamp switch to the ON position.
  2. Uncover the ambient sensor.
  3. Turn the high beam switch to the ON and then to the OFF position
Do the low and then the high beam headlamps turn on and off?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 4 
4
  1. Disconnect connector C209.
  2. Using a test lamp at C209, probe the male side between the switched headlamp battery positive voltage supply circuit and ground.
Does the test lamp illuminate?		 Go to Step 5  Go to Step 6 
5 Inspect the multifunction turn signal lever harness connector C209 for a poor connection. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 8 
6 Test for an open, high resistance or a short to ground in the headlamp battery positive voltage input circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 7 
7 Replace the ALC relay. Refer to Relay Replacement (Within an Electrical Center) or Relay Replacement (Attached to Wire Harness) in Wiring Systems.
Did you complete the repair?		 Go to Step 9  -
8 Replace the multifunction turn signal lever. Refer to Multifunction, Turn Signal Switch Replacement in Steering Wheel and Column.
Did you complete the replacement?		 Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals