LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1513 (Lighting Systems) >> Diagnostic Information and Procedures >> Hazard Lamps Inoperative

Hazard Lamps Inoperative

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Hazard Lamps Inoperative

Step Action Yes No
Schematic Reference: Exterior Lights Schematics 
Connector End View Reference: Master Electrical Component List
1 Did you perform the Lighting Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 Place the hazard switch to the ON position.
Do the hazard lamps turn ON?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Disconnect connector C215.
  2. Using a test lamp connected to ground, probe the STP HAZ fuse circuit.
Does the test lamp illuminate?		 Go to Step 5  Go to Step 4 
4 Repair the open, high resistance, or short to ground in the STP HAZ circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Is the repair complete?		 Go to Step 6  -
5 Replace the hazard warning switch. Refer to Hazard Warning Switch Replacement .
Is the repair complete?		 Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals