LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Telescope Motor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering column. Refer to Steering Column Replacement .
  3. Secure the steering column to J 41352 .
  4. Insert J 42640 into the bottom of the lower trim cover.
    5. Fig 1: Cable Assembly & Telescope Drive Motor Assembly
    GM425430Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the cable assembly (2) from the telescope drive motor assembly (1).
    6. Fig 2: Connector Clip, Telescope Drive Motor Assembly Connector, 2 Pan Head Tapping Screws & Telescope Drive Bracket
    GM425435Courtesy of GENERAL MOTORS CORP.
  6. Remove the connector clip (1) from the telescope drive motor assembly connector (2).
  7. Remove the 2 pan head tapping screws (4) from the telescope drive bracket (5).
  8. Remove the telescope drive motor assembly (2) from the telescope drive bracket (5).
  9. Remove the pan head tapping screw (3) from the telescope drive bracket (5).
  10. Remove the telescope drive bracket (5) from the jacket assembly.
scientia non olet · About LEMON Manuals